INSTALLING
APE ADJUSTABLE CAM SPROCKETS ON SUZUKI GSXR600 ('01-'16), GSXR750 ('01-'16), GSXR1000 ('01-'16)
EXHAUST
The camshaft has a single factory line on the sprocket end. The
APE sprocket adaptor is to be installed so that this line goes
in center of the two lines on the adaptor. Install the sprocket
so that the single sprocket dot is in line with the two adaptor
lines.
INTAKE
The camshaft has a single factory line on the sprocket end. Install
the APE adaptor so that the line on the cam
lines up with the single line on the adaptor. Install the sprocket
so that the single sprocket dot is 180 degrees from the two lines
on the adaptor.
Press adapter to end of cam so that adapter is FLUSH with the end of cam. No further.
We recommend red loctite
be used on the adapters to cam surfaces.
BE CAREFUL when removing stock sprockets and installing adapters.
Support the cam securely or damage can result. Do not remove
the bearings unless they need replacement. |